GarrettCom 6K8 User Manual download pdf (Page 42)

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

Step 2. Remove Chassis Cover

The Magnum 6K8-

Series chassis consists of top cover and

bottom chassis assembled together with

the help of 12 Philips-head screws. There

are 4 screws located on the topside panel

of the unit (2 each on both side), 8 for

bottom chassis base of the unit. Remove

these screws. Once these screws are

removed, the top-cover is easily slide out

to the front, off the chassis base, as shown in the picture above in Fig. 3.6.1a.

Figure 3.6.1a: Removing the Top panel from the Chassis base of the unit

Caution: Be

careful not to

disturb the

power supply.

www GarrettCom com

When the chassis

top cover has been removed,

the interior of the unit is

exposed. Looking down into

the Magnum 6K8-Series unit, notice that there are PM module installed and daughter

module would be facing your eyes on the top installed on the main board with J5 and

DSSV pins connected on the right. (See Figure 3.6.1b below).

Figure 3.6.1b: Magnum 6K8-Series, Top view without chassis cover w/ daughter

module on the top.

Note: Un-hooked the J5and DSSV connected wires

first as shown in Figure above with arrow mark.

Step 3. Remove front panel faceplate retaining

screws and screen plate

There are four retaining screws as shown with arrow

mark in Fig 3.6.1c holding the faceplate of the

chassis. Figure 3.6.1c: Top View – 6KPM-retaining screws hold Face Plate

Power LED, Pin J5

Power Supply, Pin

Dau

hter boar

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

No comments

GarrettCom 6K8 User Manual Page 42