GarrettCom 6K8 User Manual download pdf (Page 43)

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

Figure 3.6.1d: Removing PM screens Plate

www GarrettCom com

Once opened all the four retaining

screws the front cover can be removed

easily as shown in Fig 3.6.1d. (To the

left).

Carefully remove the PM screen plate

using finger or small screwdriver to

come out easily as shown in Fig

3.6.1d on the right. Just be careful on

the LEDs placed both side and hold

the faceplate tightly. There are no screws used on

holding the screen faceplate

Figure 3.6.1d: Removing Face Plate

3.6.2 Installing 6KPM Cards in the Magnum 6K8-Series

Only one front-mounted 6KPMV Module may be installed in one Magnum

6K8-Series Field Switch unit. Follow these steps to install a 6KPMV.

Step 1. Remove top

chassis cover. See

procedure in Section

3.6.1 above.

Fig 3.6.2a A Magnum 6K8

unit with main board

(motherboard) only

Step 2. Place Granddaughter board (as shown in fig.

3.6.2b) on the chassis built in stand off (female)

provided at the front of the 6K8-Series Main Board. To

place the Granddaughter board

Fig 3.6.2b Granddaughter Board shown separately

on the chassis, as shown in Figure below 3.6.2c, screw down tightly with the three 5/16

stand off (male) on the top of the Granddaughter board. The three 5/16 stand off has been

used to place the daughter board on the top of the granddaughter board and a latch

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

No comments

GarrettCom 6K8 User Manual Page 43