GarrettCom 6K8 User Manual download pdf (Page 46)

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

3.6.3 Removing 6KPM Cards

To properly remove a 6KPM card from the 6K8-Series Industrial Field Switch,

follow the 3 steps below.

Step 1. Remove chassis cover See procedures in Section 3.6.1 above.

Caution: Be sure the power cord is unplugged.

Step 2. Remove retaining screws placed on top of the 6KPMV and Face Plate

Each 6KPMV module is secured with nine retaining screws #440x3/8. These screws are

used to secure a 6KPM card in position (see Figure 3.6.3a). Remove the 9 screws to take

off the daughter module and thereafter three standoffs underneath holding the

Granddaughter board with the chassis.

www GarrettCom com

Figure 3.6.3a: 8

retaining screws shown by

arrows

Step 3. Remove 6KPM

Card

Carefully and gently pull out

the daughter board from the latching connectors,

using both hands, gripping the

board near the latch-up

connectors as shown in Fig.

3.6.3b

Figure 3.6.3b:

Removing a 6KPM Card

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

No comments

GarrettCom 6K8 User Manual Page 46